Device Settings
DeviceDevice Name
| Parameter Name | Parameter Range | Parameter Definition |
| Full Name | Not Available | Full name is used on the drop-down selection lists and in the Dante Controller for Dante channels. Full name is also used as device/Bluetooth name on the NWP series. |
| Short Name | Not Available | Short is used on the overview screen channel labels |
Version
| Parameter Name | Parameter Range | Parameter Definition |
| Firmware Version | Not Available | Indicates the installed firmware version. |
| Build Number | Not Available | Indicates the build number of the installed firmware version. |
| Update Firmware | Not Available | The available firmware version can be installed here. The latest and previous versions are both available. Using the latest AUDAC Touch version and firmware is highly recommended to get the most out of your Atellio family devices. When a new firmware version is available, the button will be highlighted in orange. |
Network Settings
| Parameter Name | Parameter Range | Parameter Definition |
| DHCP | Enable/Disable | Switch between dynamic or static IP |
| MAC | Not Available | MAC address of the device |
| IP | Not Available | The IP address of the device can be set here when DHCP is disabled (e.g. 192.168.20.170) |
| Mask | Not Available | The subnet mask can be set here (e.g. 255.255.255.0) |
| Gateway | Not Available | The gateway IP address can be set here for the device that provides access to other networks, such as a router or Layer 3 gateway (e.g., 192.168.20.1). |
| DNS1/DNS2 | Not Available | The primary and secondary/alternative DNS addresses can be set here (e.g. 1.1.1.1) |
Device Address
| Parameter Name | Parameter Range | Parameter Definition |
| Index | Enable/Disable | You can set a unique number to the device in a scenario where you have more than one of the same device. |
Time Settings
It is important to configure the time settings correctly. This is needed for the event handler time trigger to work correctly.
| Parameter Name | Parameter Range | Parameter Definition |
| Time Zone | Not Available | GMT zone can be selected based on country names |
| Server Address | Not Available | The NTP server IP address can be set in this line |
Finding an NTP Server
If your network has any restrictions, it is recommended to contact your network management to obtain the NTP address for the network you are connecting to, if the network is unmanaged or has no port restrictions then to find the IP address relative to you simply ping the address as shown below.
"europe.pool.ntp.org"
"asia.pool.ntp.org"
"oceania.pool.ntp.org"
"north-america.pool.ntp.org"
"south-america.pool.ntp.org"
"africa.pool.ntp.org"
Pin Code Setting
Pin code protection is available for the LUNA series with version 1.4.0 for configuration display. The pin code is 0000 by default.